On this page
Most cracks we are called to are cosmetic. A small number are not, and you can usually tell the difference without any equipment.
This guide was written by a civil engineer with thirty years of looking at buildings, on the principle that you should be able to triage your own wall before paying anyone.
| What you see | Likely cause | What to do |
|---|---|---|
| Hairline, map-like cracking over an area | Shrinkage in the finish coat | Cosmetic repair |
| Straight line where blockwork meets concrete | Two materials moving at different rates | Treat as a movement joint |
| Diagonal from a door or window corner | Often heat movement, sometimes not | Mark it and monitor |
| Stepped along the mortar joints | Possible structural movement | Get advice |
| Through the blocks, or wider than about 3 mm | Possible structural movement | Do not fill; get it assessed |
| Crack that keeps widening | Movement still happening | Get advice before any repair |
Start with width
Use a coin as a gauge. Everyone has one, and it beats a guess.
Hairline, barely catches a fingernail: almost always shrinkage or heat movement in the plaster or render. Cosmetic, and very common in this climate.
Visible, but a coin edge will not go in: usually still cosmetic. Keep an eye on it.
A coin edge fits: it deserves proper attention.
Wider than a coin edge, or you can see through it: stop. Do not fill it and do not paint it. Get it assessed.
Then direction and path
Fine random cracking, map-like, over an area: shrinkage in the finish coat. Cosmetic.
A straight line along a junction between materials, where blockwork meets concrete or around a column or beam: two materials moving at different rates. Treat it as a movement joint rather than filling it solid, or it simply reopens.
Diagonal from the corner of a door or window: often heat movement, sometimes not. Openings concentrate stress. Monitor it.
Stepped, following the mortar joints in blockwork: take it seriously and get advice.
Passing straight through blocks rather than around them: take it seriously. It takes more force to split a block than to open a joint.
Horizontal, part-way up a wall: uncommon, and worth advice.
Then behaviour: the test that settles it
Width and direction tell you what is likely. Movement gives you an answer.
Mark and date it. Pencil a short line across the crack at its widest point and write the date beside it. Photograph it with a coin for scale. Repeat in three months, and again after the season changes.
Not moving: whatever caused it has stopped, and a cosmetic repair is fine.
Widening: something is still happening. Get advice before any repair.
This costs nothing and tells you more than any opinion offered on a single visit, including ours.
Signs that change the picture
A crack matters more if it comes with any of these:
- Doors or windows that have started sticking or no longer latch
- Floors that feel less level than they did
- The same crack appearing on both faces of a wall
- Several cracks appearing at once, across different rooms
- Any crack that has reopened after a proper repair
Any of those together with a crack of real width is the point where you should pay for a structural engineer's assessment rather than a decorator.
External cracks have one more cost. They let water into the wall, and damp walls grow mould. The US EPA's guide to mould and moisture puts it simply: control the moisture and you control the mould, so seal outside cracks before the rain rather than after.
Why this climate produces so many harmless cracks
Al Ain has intense sun for most of the year and a wide daily temperature swing. A fifteen degree drop between afternoon and night is routine in summer, with inland highs of 38 to 44°C against 35 to 41°C on the coast. Every material on the building expands and contracts through that cycle, every day.
Finishes are thinner and less flexible than what they are applied to, so they crack first. That is why fine cracking in plaster and render is normal here in a way it is not in a temperate climate, and why most of what alarms people turns out to be nothing.
It is also why external repairs need fillers with the right flexibility. A filler harder than the surface around it cracks around its own edges. The repair fails at its edge, and people conclude the crack "came back".
Repairing a cosmetic crack so it stays repaired
- Cut it out. Open the crack to a V so the filler has something to grip. Filling a hairline on the surface fails.
- Clean it. Dust is the most common reason a repair lets go.
- Use the right material for the surface and its exposure, with a flexible filler where there is movement.
- Reinforce where the crack follows a junction, with tape or mesh, or form a movement joint.
- Prime, then paint the full wall, not just the patch.
Skipping step 1 is why most DIY crack repairs reappear within a year.
Cracks often show up after building work as new plaster dries. If you have just finished a project, our post construction cleaning steps guide covers the handover, and the villa maintenance checklist includes a walk round the outside walls each spring.
Where we stop
If we think a crack may be structural, we say so and recommend a structural engineer's assessment rather than repairing it and hoping. Filling a structural crack hides the evidence and makes the eventual diagnosis harder and more expensive.
For repairs, see our civil repairs and painting and wall repair services. Where cracking is one of several problems in an older home, a villa renovation in Al Ain can deal with the walls, finishes and services together. Get a written quote after a free survey.
Related: gypsum ceiling repair: what your ceiling stain is telling you · villa maintenance checklist